Dumb question, has anyone had experience with installing wider wheels?
I was considering using the stock rims for winter tires and getting some 8jx17 (ET?) for the front and 9jx17 (ET?) for the rear (although 7.5j front and 8j rear seems more realistic).
Haven't had the car delivered yet so i can't use willtheyfit for checking how much wheelwell space they take up.
I'd still keep stock tire measurements (Le JDM stretch ) in order to keep efficiency differences minimal, if that's even possible.
Wider wheels
You can't add 20mm spacers to the front without the original studs hitting the back of the 17" wheels. 25mm is fine though
- londiniumperson
- Posts: 1785
- Joined: Fri Oct 11, 2019 2:37 pm
Who told you that?
2020 Advance in Crystal Black Pearl on 17's - 08/2020-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
Nobody told me that, I found out myself by fitting the same 20mm set, and have the measurements and photos to show the issue. There is not enough clearance between the back of the wheel and the original studs with 20mm spacers. The tips of the original studs make contact with the wheel.
I imagine most people who have these fitted and didn't notice have just tightened them up and crushed them into the back of the alloy wheel
- londiniumperson
- Posts: 1785
- Joined: Fri Oct 11, 2019 2:37 pm
As you'll see in my topic Wheel Spacers I did mention that there was a little binding at final torquing of the wheel nuts even though I had checked the fitment. Maybe the H&R wheel spacers are slightly different, I was lucky or the studs do touch the wheel pockets. However, one of the front wheels was recently taken off by a local tyre fitter to repair a puncture and they didn't comment on this. Anyway. I'll be needing some tyres fairly soon so will double check then.stzrd wrote: ↑Sun Oct 16, 2022 9:51 amNobody told me that, I found out myself by fitting the same 20mm set, and have the measurements and photos to show the issue. There is not enough clearance between the back of the wheel and the original studs with 20mm spacers. The tips of the original studs make contact with the wheel.
I imagine most people who have these fitted and didn't notice have just tightened them up and crushed them into the back of the alloy wheel
I also remember testing out the 25mm spacers on the front and didn't like the look with the additional protrusion outside the wheel arches.
2020 Advance in Crystal Black Pearl on 17's - 08/2020-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
You're right! From an efficiency standpoint it doesn't make much sense at all. But i've always loved the idea of adding new wheels on a car to give it a more ""unique"" or specific look. The e is already a nice looking vehicle, but a new look wouldn't hurt!
The hardest part is finding wheels that have both 8jx17 and 9jx17 configurations (or more realistically even just 7j and 8j). So far JR wheels seem to be the only option in that case, as they offer the widest variety of configs, at a premium obv
I've never liked the idea of spacers either, i believe they mess too much with suspension geometry compared to a (properly offsetted) wider wheel.
Ex Audi S3 8P -> Honda e (12/2022) +
2021 Lexus UX250h 4WD "Midnight" (01/2024)
2021 Lexus UX250h 4WD "Midnight" (01/2024)
- londiniumperson
- Posts: 1785
- Joined: Fri Oct 11, 2019 2:37 pm
Fitting wider wheels almost always requires a change of offset to avoid touching the suspension, especially going 1.5” wider and then the geometry will be effected anyway.Rizzoe wrote: ↑Mon Oct 17, 2022 10:52 amYou're right! From an efficiency standpoint it doesn't make much sense at all. But i've always loved the idea of adding new wheels on a car to give it a more ""unique"" or specific look. The e is already a nice looking vehicle, but a new look wouldn't hurt!
The hardest part is finding wheels that have both 8jx17 and 9jx17 configurations (or more realistically even just 7j and 8j). So far JR wheels seem to be the only option in that case, as they offer the widest variety of configs, at a premium obv
I've never liked the idea of spacers either, i believe they mess too much with suspension geometry compared to a (properly offsetted) wider wheel.
When I considered spacers, I felt that the best option was to ensure I purchased some that were TÜV certified, so at least they have been checked to comply with a safety standard.
2020 Advance in Crystal Black Pearl on 17's - 08/2020-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
Do you know how much space there is between inner edge of the tire and the strut assembly on the rear axle?londiniumperson wrote: ↑Mon Oct 17, 2022 12:37 pm
Fitting wider wheels almost always requires a change of offset to avoid touching the suspension, especially going 1.5” wider and then the geometry will be effected anyway.
When I considered spacers, I felt that the best option was to ensure I purchased some that were TÜV certified, so at least they have been checked to comply with a safety standard.
Ex Audi S3 8P -> Honda e (12/2022) +
2021 Lexus UX250h 4WD "Midnight" (01/2024)
2021 Lexus UX250h 4WD "Midnight" (01/2024)
- londiniumperson
- Posts: 1785
- Joined: Fri Oct 11, 2019 2:37 pm
No I don’t, it’s probably best that you check for yourself as I wouldn’t want to be responsible if there was an issue with any measurement I’d provided and not proven to myself was 100% accurate.Rizzoe wrote: ↑Tue Oct 18, 2022 3:49 pmDo you know how much space there is between inner edge of the tire and the strut assembly on the rear axle?londiniumperson wrote: ↑Mon Oct 17, 2022 12:37 pm
Fitting wider wheels almost always requires a change of offset to avoid touching the suspension, especially going 1.5” wider and then the geometry will be effected anyway.
When I considered spacers, I felt that the best option was to ensure I purchased some that were TÜV certified, so at least they have been checked to comply with a safety standard.
Is there a reason that you can’t do this yourself?
2020 Advance in Crystal Black Pearl on 17's - 08/2020-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
2015 VW Tiguan (Pure White) - 04/2018-Current
1991 Honda Beat PP1 (Festival Red) - 11/2022-Current
-
- You may also be interested in...
- Replies
- Views
- Last post